The IC-718 is equipped with a minimum number of buttons and controls for simple feature selection. The 10-key pad on the front panel allows direct entry of an operating frequency or a memory channel number. The auto tuning step function is activated when turning the dial quickly and helps speed up tuning. The band stacking register is convenient when changing operating bands.
Front Mounted Loud Speaker
The IC-718 has the speaker mounted on the front panel. With the speaker facing the operator, audio will be heard clearly and directly while operating.
Optional* DSP Capability, UT-106
The optional DSP unit gives you noise reduction and auto notch filter functions for extra receiver performance.
*Already installed for USA version.
General Coverage Receiver
The IC-718 has 0.03–29.999999MHz* general coverage receive capability.
*Guaranteed range: 0.5–29.999999 MHz
- Built-in electronic keyer
- Built-in microphone compressor
- Combined squelch and RF gain control
- Preamplifier and attenuator
- 101 memory channels
- CW full break-in
- IF shift interference rejection
- 1Hz tuning
- VOX function for hands-free operation
- Optional automatic antenna tuner
- Digital S/RF meter
(Differs according to version)
|Tx||1.8, 3.5, 7, 10, 14, 18, 21, 24, 28MHz bands|
|Modes||USB, LSB, CW, RTTY, AM|
|Frequency stability||Less than ±200Hz
(From 1 min. to 60 min. after power ON)
|Maximum current drain||20A at 13.8V DC|
|Power supply requirement||13.8V DC ±15%|
|Antenna connector||SO-239 (50Ω)|
|Number of memory
(99 regular, 2 scan edges)
(W×H×D; Projections are not included)
|Weight (approx.)||3.8kg; 8.4lb|
*1 Guaranteed range 0.5–29.999MHz.
|Output power||SSB, CW, RTTY||2–100W|
|Spurious emissions||Less than –50dB|
|Carrier suppression||More than 40dB|
|Unwanted sideband||More than 50dB|
|Microphone connector||8-pin connector (600Ω)|
Preamp ON SSB, CW, RTTY, AM: at 10dB S/N FM, WFM: at 12dB SINAD
|SSB, CW, RTTY||1.8–29.999MHz 0.16μV|
|Sensitivity for RED (Less than)
SSB, AM, FM: at 12 dB SINAD
|SSB (2.4 kHz)||1.8–2.999 MHz 10 dBμV emf
3.0–29.999 MHz 0 dBμV emf
|AM (6 kHz, 60% modulation)||1.8–2.999 MHz 16 dBμV emf
3.0–29.999 MHz 6 dBμV emf
|Selectivity||SSB, CW, RTTY||2.1kHz/–6dB
|Spurious and image
|More than 70dB
(at 10% distortion with an 8Ω load)
|More than 2.0W|
|2-conductor 3.5 (d) mm (1⁄8″)/8Ω|
The LCD display may have cosmetic imperfections that appear as small or dark spots. This is not a malfunction or defect, but a normal characteristic of LCD displays.
All stated specifications are subject to change without notice or obligation.
- Hand microphone
- DC power cable
- Spare fuses
(May differ depending on the version)
POWER SUPPLY CABLES
Ingress Protection (IP) Code
Ingress Protection (IP) ratings define the level of protection provided by enclosures to prevent the ingress of foreign objects (dust) and liquid into the electrical equipment.
International Standard IEC 60529 outlines an international classification system that describes the sealing characteristics of electrical equipment.
The classification system uses the “IP” code, or “Ingress Protection” code, to define the level of seal.
An IP number contains two numbers (i.e. IP67) in most instances which relate to the level of protection provided by an enclosure or housing.
Either number may be shown as “X” (i.e. IPX6 / IP7X) to indicate the “X” part is not tested.
Degrees of Solid Particle Protection – 1st Digit
|IP6x||No ingress of dust; complete protection against contact. (Dust tight)|
|IP5x||Protected from the amount of dust that would interfere with normal operation. (Dust protected)|
Degrees of Liquid Ingress Protection – 2nd Digit
|IPx8||Protected against continuous immersion in water.
Depth and duration specified by model.
|IPx7||Protected against temporary immersion in water for 1 m (3.3 ft) for 30 minutes|
|IPx6||Protected against water projected by powerful jets from any direction.
100 L per minute by a powerful jets (12.5 mm) for 3 minutes.
|IPx5||Protected against water projected by jets from any direction.
12.5 L per minute by a nozzle (6.3 mm) for 3 minutes.
|IPx4||Protected against water splashed against the equipment from any direction|