Firmware Download

Download the old version

    • Amateur
    • All Mode
    • All Mode
Download Type Firmware
Model name IC-7610
Version Version 1.20
Update 2018/08/24
Major changes

Changes in this version

  • The [USB 2] I/Q baseband signal output port is now supported.
  • The MAC address display is added to the screen in
    Set Menu > Others > Information.

To update the firmware

  • To update from firmware version 1.05 or older to 1.11, the IC-7610 needs to have firmware version 1.06 installed.
  • To revert from firmware version 1.20 or later to 1.06 or older, the IC-7610 needs to have firmware version 1.11 installed.
  • Thoroughly read Section 6, SD CARD/USB FLASH DRIVE, in the BASIC MANUAL and the Section 13, UPDATING THE FIRMWARE, in the ADVANCED MANUAL, and follow the instructions displayed on the IC-7610 LCD screen.
  • BE SURE to make a backup copy of your data settings to an SD card/USB flash drive before updating the firmware.
  • The firmware will be updated to the following versions.
    Main CPU: 1.20
    Sub CPU: 1.04
    Front CPU: 1.01
    FPGA: 1.06


  • Also download the related software "IC-7610 USB I/Q Package for HDSDR" from here.
File Size 7.51MB
File Type ZIP
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.