USB I/Q Package for HDSDR Download
- All Mode
- All Mode
|Download Type||USB I/Q Package for HDSDR|
This software package is for using the I/Q output of the IC-7610 with the HDSDR (freeware Software Defined Radio: http://www.hdsdr.de/). The software will install the USB device driver for the [USB 2] port and the ExtIO DLL file for the HDSDR.
Thoroughly read the instruction guide before installing the software.
The IC-7610 needs firmware version 1.20 or later to utilize the [USB 2] port.
|Manual||manual download page|
Regarding this Download Service.
When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.
Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.
You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.