Firmware Download

Download the old version

Download Type Firmware
Model name IC-7610
Version Version 1.41
Update 2024/05/15
Major changes

Changes from Version 1.30

  1. [Added DPD function]
  2. - Supported the Digital Pre-Distortion (DPD) function.
  3. Pre-adjustment is required to use the DPD function. Refer to "Information IC-7610 Version 1.41" for details.

  1. [Added linkage function with IC-PW2]
  2. - Supported for the Linked manual tuning with IC-PW2.
  3. - Supported for the IC-PW2 Dual Connection Mode.
  4. - Supported for the IC-PW2 Transmission Interlock control.
  6. [Any other changes]
  7. - Improved the Manual All Reset operation.
  8. When the All Reset cannot be performed from the RESET screen, holding down the [MAIN/SUB] and [CHANGE] keys and turning ON with the [POWER] key will manually perform an All Reset. The Manual All Reset operation is improved by connecting the external power supply instead of the [POWER] key.
  9. - Fixed a bug that caused the Noise Squelch to sometimes not work when the operation mode was set to the FM mode while the Dualwatch or the Split function was ON.

For details, please refer to "Information IC-7610 Version 1.41."


To update the firmware

  • To update from firmware version 1.05 or older to 1.11, the IC-7610 needs to have firmware version 1.06 installed.
  • Thoroughly read Section 6, SD CARD/USB FLASH DRIVE, in the BASIC MANUAL and the Section 13, UPDATING THE FIRMWARE, in the ADVANCED MANUAL, and follow the instructions displayed on the IC-7610 LCD screen.
  • BE SURE to make a backup copy of your data settings to an SD card/USB flash drive before updating the firmware.
  • The firmware will be updated to the following versions.
    • Main CPU: 1.41
    • Sub CPU: 1.06
    • Front CPU:1.01
    • FPGA: 1.11
File Size 8.02MB
File Type zip
Manual manual download page

Firmware Update Information

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.