|Version||Version 1.13 for USA version|
This firmware is for the USA version that has a serial number beginning with "16".
Changes from Version 1.11
The CS-R30 programming software used with this firmware can be downloaded here.
To update the firmware
1. Download and unzip the firmware data (for example, R30U113.dat) and copy it into the “IC-R30” folder that is on your microSD card.
2. Insert the microSD card with the firmware data into the receiver.
3. We recommend that you make a backup of the settings and memories, because all the settings and memories may be reset after updating the firmware.
3-1. Display the SD CARD screen in the Menu.
4. Update the firmware.
4-1. Display the SD CARD screen in the Menu.
5. If the settings and memories have been reset, load the settings and memories that have been backed up onto the microSD card.
5-1. Display the SD CARD screen in the Menu.
After updating the firmware, the Version Information in the OTHERS will be as follows.
|Manual||manual download page|
Regarding this Download Service.
When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.
Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.
You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.