Cloning software Download

Download the old version

    • Options
    • SOFTWARE
    • PROGRAMMING SOFTWARE
Download Type Cloning software
Model name CS-R30
Version Version 1.10
Update 2018/09/14
Major changes

Changes in this version

  • Added the setting items related to the enhanced functions in IC-R30 firmware version 1.10 listed below.
  • Improved Automatic backlighting
  • Eliminated restrictions of program scan edge settings
  • Improved Skip function
  • Added Duplex check function
  • Connected memory group and group link settings
  • Added Bluetooth® SCO Link automatic disconnect

To update the software

  • Follow the section Updating the CS-R30 in the CS-R30 Update information.
  • You must have the CS-R30 cloning software installed before you can install this update.
  • Install firmware version 1.10 (USAnon-USA) onto the IC-R30 to use CS-R30 version 1.10.
Note
File Size 4.46MB
File Type ZIP
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.