This is the first release.
The CX-10G firmware can be updated using an SD card from the connected IC-905.
To update the firmware
1. Download and unzip the firmware data (for example, CX10GE101.dat) and copy it into the “CX-10G” folder in the IC-905 folder on your SD card.
2. Insert the SD card with the firmware data into the transceiver.
3. Update the firmware.
3-1. Display the SD CARD screen in the Menu.
After updating the firmware, the Version Information in the OTHERS Set will be as follows.
|manual download page
Regarding this Download Service.
When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.
Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.
You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.