Cloning software Download
|Download Type||Cloning software|
Changes from Revision 1.20
Improved that the IC-R8600 is not displayed in the COM port search window list, depending on the PC.
You must have the CS-R8600 cloning software installed before you install this update.
CS-R8600 Revision 1.21 can read icf files that are made by Revision 1.20 or earlier.
The driver for USB 3.0 is downloadable here.
|Manual||manual download page|
Regarding this Download Service.
When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.
Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.
You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.