Cloning software Download

Download the old version

Download Type Cloning software
Model name CS-IP100H
Version Version 2.05
Update 2021/11/05
Major changes

Changes from Version 2.03

  • Added compatibility with OPC-478UC-1 programming cable.
Note

Use with the IP100H that has firmware Version 2.17 or later installed.

OS Windows® 8.1 (64bit/32bit) (except the "RT" version) and Windows® 10 (64bit/32bit)
File Size 5.03MB
File Type zip
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.