Firmware Download

Download the old version

Download Type Firmware
Model name IC-7300
Version Version 1.40
Update 2021/02/26
Major changes

Changes from Version 1.30
[Spectrum scope is improved]
- A Scroll mode that can seamlessly change the displaying scope range, depending on the operating frequency, is added.
- A popup screen that displays when SPAN or EDGE change is added.
- The number of FIX EDGE memories is expanded to 4.
- Each band independently memorizes the Reference level.
- Improved the Scope function of the RS-BA1.


[Preset function is added for FT8 operation]
- A Preset function that can set each operation is added.


[Multi-function dial is enhanced]
- A Multi-function dial now works as a memory channel selector in the Memory mode.
- A Multi-function Menus Customization function is added.
- A function indicator for the Multi-function dial is added.


[Other changes]
- A Front Key Customization function that can change the function of [VOX/BK-IN], [AUTOTUNE], [△], and [▽] is added.
- A MIC Key Customization function that can change the function of [UP] and [DOWN] is added.
- The Band Stacking Register window is added.
- While operating in the Data mode, the receive tone control is deactivated.
- The default setting of the CI-V USB Port is changed to “Unlink from [REMOTE].”

Refer to INFORMATION IC-7300 Version 1.40 for details.

The Scroll mode for the RS-BA1 Version 2 software will be added to Version 2.30.

Note

To update the firmware

  • ・Thoroughly read Section 8. USING AN SD CARD and Section 15. UPDATING THE FIRMWARE of the FULL MANUAL and follow the instructions displayed on the IC-7300 LCD screen.
  • ・This update initializes the transceiver's settings when updating from a firmware earlier than version 1.40. Save your current settings before updating the firmware, and then write it back to keep the previous setting on the updated firmware.
  • ・The firmware will be updated to the following versions.
  •     Main CPU: 1.40
  •     DSP Program: 1.07
  •     DSP Data: 1.00
  •     FPGA: 1.13
File Size 2.73MB
File Type zip
Manual manual download page
Document

Firmware Update Information

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.