USB Driver Download
- All Mode
- All Mode
|Download Type||USB Driver|
・The ID-52A/ID-52E is now supported.
The driver supports the following transceivers (as of November 2020). After installing the driver, connect the transceiver to the PC, and then the USB driver is automatically installed to add a COM port.
Before downloading the driver, please thoroughly read "USB driver installation guide" for installation details and what is required for the installation.
This driver is for only Windows® 8.1 (except "RT" version), and Windows® 10.
|Manual||manual download page|
Regarding this Download Service.
When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.
Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.
You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.