|Version||Version 1.11 for non-USA version|
This firmware is for non-USA versions that have a serial number beginning with other than "16".
Changes from version 1.10
・Fixed the problem of when the ANL of the band that is not used is ON, while the Dualwatch function is OFF, the received DCR audio may not be output from the speaker.
To update the firmware
Thoroughly read Section 2 microSD CARD and Section 9 UPDATING THE FIRMWARE in the ADVANCED MANUAL, and follow the instructions displayed on the IC-R30.
|Manual||manual download page|
Regarding this Download Service.
When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.
Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.
You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.