Firmware Download

Download the old version

Download Type Firmware
Model name IC-9700
Version Version 1.23
Update 2020/04/03
Major changes

Changes from Version 1.21

  • Changed the screen drawing sequence to keep the previous frequency screen layout when exiting from a function displayed in fullscreen.
  • Fixed an issue where the standby beep may sound approximately two seconds after receiving a reply when simply pushing PTT to key up the repeater.

Changes from Version 1.22

  • Fixed an issue where the DV Gateway function may not work properly when it is turned off and then turned on again.
  • Fixed an issue where the RTTY DECODE screen was displayed while leaving the Mark Frequency and Shift Width settings at other than 2125Hz and 170Hz.

To update the firmware

  • Thoroughly read 13. UPDATING THE FIRMWARE of the ADVANCED MANUAL and follow the instructions displayed on the IC-9700 LCD screen.
  • This update initializes the transceiver's settings when updating from a firmware earlier than version 1.20. Save your current settings before updating the firmware, and then write it back to keep the previous setting on the updated firmware.
  • The firmware will be updated to the following versions.
    Main CPU: 1.23
    Sub CPU: 1.00
    Front CPU: 1.00
    FPGA Program: 1.06
    FPGA Data: 1.00
    DV DSP: 1.06
Note
File Size 12.95MB
File Type zip
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.