Firmware Download

Download the old version

    • Land Mobile
    • RoIP & Network
    • RoIP Gateway
Download Type Firmware
Model name VE-PG3
Version Version 2.03
Update 2014/10/21
Major changes

Improvements are listed below.

Bridge mode:
• dPMR Mode 2 is supported
• IP100H Bridge mode connection is supported
• Serial control of the IC-F5060/F6060 series is supported
• Serial communication between VE-PG3s is supported
• The "Call Back RX to TX" function is added to the "Transceiver Control" setting


Converter mode:
• dPMR Mode 2 is supported
• Serial communication between VE-PG3s is supported
• The "Call Back RX to TX" function is added to the "Transceiver Control" setting
• Squelch control from a transceiver is supported
• The "Always Send during Talking" item is added to the "PTT Control Type from the Telephone" setting
• A busy tone is added when a target of the IP100Hs or the IP100FSs is not connected to the system, or is out of range*1

*1 To use this function, the following firmware are necessary
• IP1000C version 1.33 or later
• IP100H version 1.33 or later
• IP100FS version 1.31 or later


Notice:
• If you update to version 2.03 from version 1.32 or earlier, you cannot downgrade to version 1.32 or earlier again.
• You cannot use setting files made by version 2.03 or later using version 1.32 or earlier.

Note
File Size 3.72MB
File Type ZIP
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.