Cloning software Download

Download the old version

    • Options
    • SOFTWARE
    • PROGRAMMING SOFTWARE
Download Type Cloning software
Model name CS-7100
Version Revision 1.10
Update 2015/05/21
Major changes

Improvements

[CI-V Output (for ANT)] setting item is added to output the status such as frequency and so on to the antenna controller from the [REMOTE] jack and the [USB] connector.

Refer to CS-7100 Update information— Revision 1.10 for details.

 

Note

  • You must have the CS-7100 cloning software installed BEFORE you update to revision 1.10.
  • Install the Release E4 version of the IC-7100 firmware to use the added feature in CS-7100 Revision 1.10. Download the firmware here.
  • CS-7100 Revision 1.10 can read icf files that are made by Revision 1.01 or earlier.
  • The latest USB driver (version 1.20) is not included in the CS-7100 revision 1.10 file. To use a USB 3.0 device, download the necessary USB 3.0 compatible driver here.
Note
File Size 4.94MB
File Type ZIP
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.