Firmware Download

Download the old version

    • Amateur
    • All Mode
    • All Mode
Download Type Firmware
Model name IC-7300
Version Version 1.30
Update 2018/07/20
Major changes

Changes in this version

  • A SET MODE item is added to expand the transmission passband width for the SSB data mode up to "100 to 2900 Hz".
  • A SET MODE item is added to make the USB SEND/USB Keying function active immediately after USB port connection. The Menu structure is changed accordingly.

Refer to IC-7300 Firmware Update Information Ver.1.30 for more details.

To update the firmware

  • Thoroughly read Section 8. USING AN SD CARD and Section 15.
    UPDATING THE FIRMWARE of the FULL MANUAL and follow the instructions displayed on the IC-7300 LCD screen.
  • The firmware will be updated to the following versions.
    Main CPU: 1.30
    DSP Program: 1.07
    DSP Data: 1.00
    FPGA: 1.13
Note
File Size 2.69MB
File Type zip
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.